Warmup® electric underfloor heating, the world’s best-selling floor heating brand™, provides warmth throughout the whole room, giving a whole new meaning to heating and comfort. Warmup underfloor heating offers heat-up time in minutes rather than hours, avoiding overheating and wasting energy. Warmup electric underfloor heating mats are low build (3mm) and perfect for heating up a large or regular-shaped room.
Warmup StickyMat system is suitable for all projects: new-build, retrofits and refurbishments.
The StickyMat System consists of a thin loose wire evenly spaced and taped to a glassfibre mesh with pressure sensitive adhesive, which allows for the fastest and most secure installation method of electric underfloor heating. The system is available in a choice of 150 W/m² and 200 W/m² heat outputs.
150W/ m2 – power variant can provide primary heating in well-insulated areas. Insulation boards retain heat in the room for longer. More importantly, they prevent downward heat-loss. The 150W/ m2 StickyMat can be laid on both timber and concrete subfloors.
The heating cable is ultra thin, only 1.8mm. It has multi-strand dual- core, double-insulated using advanced fluoropolymer coatings. This means you can tile directly above it with a thin layer of flexible tile adhesive.
With only one power lead to wire, it is easy to install and will not raise floor levels.
This system is suitable for all applications, providing primary or secondary heating in all rooms or projects that adheres to Building Regulations.
The Matting System is designed for installation under ceramic or natural stone tiled flooring. Thermaly insulated tile backer board is the ideal surface for laying underfloor heating mats on top off. Provinding a flat surface that is insulated against heat loss: Thermal Insulation Tile Backer Board
Can I use the Warmup StickyMat System as a primary Heat Source?
If your room is well insulated and complies with modern insulation levels you should be able to use Warmup as the sole heat source. However, if your house is an older property with low insulation properties it is likely that an additional heat source may be required. Heat loss calculations can be carried out by a builder, architect or heating engineer.
What type of flooring can I use over the StickyMat system?
The StickyMat system is specifically designed for use under tiles and natural stone. For other floor coverings please consult with the Warmup technical team on 0845 345 2288.
Can the StickyMat system be cut?
In order to fit the mat into a specific area, it may be necessary to cut and turn the glass fibre mesh. Care must be taken not to cut or damage the heating wire. The heating wire/heating mat CANNOT be shortened - the correct size heater must be installed on the available floor space.
Can the floor probe / power supply cables be extended?
Both these wires can be extended up to 50 metres - please consult a qualified electrician for advice on extending the cable.
How long must I wait after installation before turning the system on?
The underfloor heating cannot be turned on until the flexible tile adhesive is fully dried. Please allow a minimum of 7 - 10 days. Turning the system on too early can force the flexible tile adhesive to dry too quickly, causing it to crack.